Spa Pump Impellers
The impeller is the spinning part inside the wet end that actually moves water. When it cracks, loses vanes or wears out, the motor keeps running but flow drops, and jets that were strong become weak. If the volute housing is sound, replacing only the impeller is the cheapest repair. This collection lists impellers by horsepower, shaft length and outside diameter so you can match the one in your pump.
How to match an impeller
- Horsepower. Listings run from 0.5 HP to 5 HP. The impeller is sized to the pump's rated horsepower, so match your motor nameplate.
- Shaft length (SL). Shown in the title as "SL". It must fit the motor shaft and the wet end it sits in.
- Outside diameter (OD). Shown as "OD". It has to clear the volute. Two impellers with the same horsepower can have different OD.
- Brand and part number. Our impellers come from Waterway, Aqua-Flo by Gecko, LX, Jacuzzi, Sundance Spas, Vico, Gecko Alliance and Sta-Rite. Match the part number on the old impeller or your wet end where you can. Do not assume brands interchange because the horsepower matches.
- Some listings give OD only. Where a title shows no SL, check the product page and compare against your old impeller before ordering.
Not sure whether you need an impeller or a full housing? Compare with pump wet ends, or replace the full unit from main pumps.
Signs the impeller has failed
- The motor runs normally but jets are weak or dead.
- Grinding or rattling from the wet end, which can mean debris has chipped or cracked it.
- Visible cracks, missing vanes or a stripped shaft bore when you inspect it.
- Repeated low-flow or no-flow fault codes while the motor spins freely.
Rule out the cheaper causes first: a clogged filter, a closed valve or an air lock. Our pump diagnosis guide covers the checks.
Replacing it
The wet end must come off the motor to reach the impeller, which disturbs the shaft seal. Plan to replace the seal at the same time from seals and gaskets. See spa pump seal leak: signs and replacement for what to look for.
Frequently asked questions
Can I replace just the impeller instead of the wet end?
Yes, if the housing and diffuser are undamaged. If the housing is cracked or warped, replace the wet end.
Does the impeller horsepower have to match my motor?
Yes. Use the horsepower on the motor nameplate. A two-speed pump carries one rated horsepower, so order for that figure.
Can I use a Waterway impeller in an Aqua-Flo pump?
Do not assume so. Shaft length, OD and bore differ by model. Match the part number or measure your old impeller against the listing.
How do I measure my old impeller?
Measure the outside diameter across the vanes and the shaft length of the hub, and note any numbers molded into it. Compare those with the SL and OD in the listing title.
Is a noisy pump always the impeller?
No. Noise can also come from worn motor bearings, cavitation from low water or a clogged filter, or debris in the wet end. Check those before ordering parts.

















